Re: cannot install update

I was up to 95 updates, with about 3 months worth of searching for answers
(in my "free" time) when I finally came across this thread. I finally
figured out that I had been able to download the updates, but just not
install them...

I had tried about a half dozen other methods, but the one suggested by
sdlomi2 worked like a charm the first time. Now I am busy finally installing
the many MB of updates, but at least it is working "properly" now... Thanks
for solving my problem.


"sdlomi2" wrote:

>
> "Richard C" <RichardC@discussions.microsoft.com> wrote in message
> news:7F28CB15-01DF-42E0-826E-768E9C5DCF3C@microsoft.com...
> > After I repaired the installation of my windows XP, I went to Windows
> > Updates, however I can only downloaded the updates but not install any of
> > the
> > updates (92 of them).
> >
> > The last few error codes are: 0x80004002
> >
> > Please help
>
> This works for me--several times with slight variations in symptoms,
> last week:
> I have just tried the suggestion below, recommended by Bob ((leanin'
> cedar)
> in a previous email on this site (see Joe Medford - 8.10.07) - it worked.
>
> 1. Click on Start and then click Run,
> 2. In the open field type "REGSVR32 WUAPI.DLL" (without quotation marks) and
> press Enter.
> 3. When you receive the "DllRegisterServer in WUAPI.DLL succeeded" message,
> click OK.
> 4. Please repeat these steps for each of the following commands:
> REGSVR32 WUAUENG.DLL
> REGSVR32 WUAUENG1.DLL
> REGSVR32 ATL.DLL
> REGSVR32 WUCLTUI.DLL
> REGSVR32 WUPS.DLL
> REGSVR32 WUPS2.DLL
> REGSVR32 WUWEB.DLL..........hth, sdlomi2
>
>
>