Printer communication problem in x64 resolved

Hi:
Just a quick post to report that after three days of trying to get my
Canon i9100 to communicate with any program whatsoever, I discovered the
USB Filter loaded when I set up my ATI drivers was the culprit --
uninstalling the USB filter has left me a happy camper, with a fully
functional printer.
Just wish someone else had discovered this ahead of me (or reported it)
so a quick search (lazy me) would have brought the solution to
me
bst
adg


--
adg

If you would, please let me the step by instructions for this resolution. It
may apply to my "printer won't stay installed" post.

thx

"adg" wrote:

>
> Hi:
> Just a quick post to report that after three days of trying to get my
> Canon i9100 to communicate with any program whatsoever, I discovered the
> USB Filter loaded when I set up my ATI drivers was the culprit --
> uninstalling the USB filter has left me a happy camper, with a fully
> functional printer.
> Just wish someone else had discovered this ahead of me (or reported it)
> so a quick search (lazy me) would have brought the solution to
> me
> bst
> adg
>
>
> --
> adg
>

Hi:
I opened Control Panel > Uninstall Programs > Chose the ATI Catalyst
entry
Then, when it opened, I chose Uninstall, Custom and then chose USB
Filter.
Once that was uninstalled, my printer again worked.
Did this in both an old installation of x64 and a clean install on a
new drive and it worked both times.
Hope this helps
adg


--
adg