Installation problem with RTm Build after entering in my cd key

Hello,

I have recently downloaded from MS the RTM version of Vista and got my key.
It all goes well, I then enter in the CD key I got. When I click next, to
go to the next stage it just hangs on the screen where I entered in my key.

I am using the 64 bit version. Also of the Beta versions installed just
fine.

My computer Specs:

Model : AMD Athlon(tm) 64 X2 Dual Core Processor 4800+
Bus(es) : ISA AGP PCI PCIe IMB PCMCIA CardBus USB FireWire/1394 i2c/SMBus

Chipset 1
Model : Clevo/Kapok Computer K8T890 CPU to PCI Bridge
Front Side Bus Speed : 2x 1000MHz (2000MHz data rate)

Chipset 2
Model : Advanced Micro Devices (AMD) Athlon 64 / Opteron HyperTransport
Technology Configuration

Physical Storage Devices
Hard Disk : HTS721010G9SA00 ATA Device (93GB)
Hard Disk : HTS721010G9SA00 ATA Device (93GB)
Hard Disk : GENERIC USB Storage-CFC USB Device
Hard Disk : GENERIC USB Storage-MSC USB Device
Hard Disk : GENERIC USB Storage-SDC USB Device
Hard Disk : GENERIC USB Storage-SMC USB Device
CD-ROM/DVD : TSSTcorp CD/DVDW SN-W082B ATA Device (CD 24X Rd, 24X Wr) (DVD
3X Rd, 3X Wr)
CD-ROM/DVD : TSSTcorp CD/DVDW SN-W082B ATA Device (CD 24X Rd, 24X Wr) (DVD
3X Rd, 3X Wr)


I am not to sure what to do next. I have like just connected one of my SATA
disks and still the same problems.

I have attached in a word document the full specs of my computer.

Any suggestions

regards

Mark