Multiple SATA Hard drives

I have 3 SATA hard drives on my system Vista will only see the one it's
installed on (C. Drives D: and E: are only under my devices not in
Computer details. This is an RC1 version Built 5600. I can not see any of
the files or access the drives from Vista. Workes fine if I start my XP Pro
on drive D:.

The partition(s) wouldn't happen to be dynamic would they?

--

Crosspost, do not multipost http://www.blakjak.demon.co.uk/mul_crss.htm
How to ask a question http://support.microsoft.com/kb/555375
How to Post http://www.dts-l.org/goodpost.htm
http://www.db-pc.com
--------------------------------------------------------------------------------

"Simplex" <Simplex@discussions.microsoft.com> wrote in message
news:00BC4D73-B42A-4011-8632-EB9838261B48@microsoft.com...
>I have 3 SATA hard drives on my system Vista will only see the one it's
> installed on (C. Drives D: and E: are only under my devices not in
> Computer details. This is an RC1 version Built 5600. I can not see any
> of
> the files or access the drives from Vista. Workes fine if I start my XP
> Pro
> on drive D:.

You may have 2 different SATA chipset on your motherboard, like I have
on my ASUS motherboard. Make sure you have drivers for each.

Billy


On Mon, 5 Feb 2007 15:42:01 -0800, Simplex
<Simplex@discussions.microsoft.com> wrote:

>I have 3 SATA hard drives on my system Vista will only see the one it's
>installed on (C. Drives D: and E: are only under my devices not in
>Computer details. This is an RC1 version Built 5600. I can not see any of
>the files or access the drives from Vista. Workes fine if I start my XP Pro
>on drive D:.

Simplex wrote:
> I have 3 SATA hard drives on my system Vista will only see the one it's
> installed on (C. Drives D: and E: are only under my devices not in
> Computer details. This is an RC1 version Built 5600. I can not see any of
> the files or access the drives from Vista. Workes fine if I start my XP Pro
> on drive D:.

I had a similar situation after installing Vista to it's own partition
in a dual-boot setup. I used the Drive Management console to manually
assign drive letters to the other drives, and then they were displayed
in Windows Explorer.