Re: sfc /scannow question.
I think you are misunderstanding. If it ran to 100% you should see the
results even if there was not a problem. Did you run it from a command
"irishgodfather" <firstname.lastname@example.org> wrote in message
> Brink;637454 Wrote:
>> Hi Bill,
>> Welcome to Vista x64 Forums. arty:
>> If you received 100% complete afterwards, then you are fine. If not,
>> then you might run it again to see. It should give you some message
>> after it runs.
> Thanks Shawn.
> It ran to 100% so I guess I'm ok.