Reading more I found out it was the camera software and removed it all.
That error is gone. I will now reinstall and maybe this time it will work
correctly.

--
...Chip..
For better or worse, we're
running Windows Vista


"Lonzo" <quickdraw@cox.neet> wrote in message
news:uOk5BQceHHA.2316@TK2MSFTNGP04.phx.gbl...
> If I had to guess it would be the device/software of the device, that is
> continuously connected. I'm sure you're right about Canon. I'm pretty
> sure they will act pretty much just like every other company and blame it
> on something else (in this case probably vista).
>
>
> "Charles Shapiro" <cshapiro2@cox.net> wrote in message
> news:O2Td0kSeHHA.588@TK2MSFTNGP06.phx.gbl...
>>I must not have spelled it correctly or something as you have shown me it
>>is
>> there and it is something Canon is doing. Now I have to figure out if
>> it's
>> the camera software or the scanner software. I'm thinking scanner
>> software
>> and it's hooked up all the time and the camera is not, but that just a
>> guess. I am sure Canon will be very helpful when I show this to them.
>> NOT!
>>
>> Thanks.
>>
>> ..Chip..
>> For better or worse, we're
>> running Windows Vista
>>
>> ---
>> "Lonnie" <quickdraw@cox.neet> wrote in message
>> news:%2324W3aSeHHA.596@TK2MSFTNGP06.phx.gbl...
>>>I thought you said you googled this? I got a bunch of stuff when I
>>>googled it. Here is the link.
>>>
>>>
>>>
>>> http://www.google.com/search?q=CNDND...x=&startPage=1
>>>
>>>
>>>
>>>
>>>
>>> "Charles Shapiro" <cshapiro2@cox.net> wrote in message
>>> news:eBco9CSeHHA.3536@TK2MSFTNGP04.phx.gbl...
>>>>I am now getting an error on reboot that says "stopped working and was
>>>>closed" it does not tell me what..
>>>>
>>>> Windows Vista Ultimate, ßeta nvidia drivers installed. (this started
>>>> before these drivers were installed). I was running the release
>>>> drivers 100.65, but these would not allow the computer to go into power
>>>> management, and didn't work (correctly on my setup) with FSX either, so
>>>> I removed them and installed the ßeta drivers 101.41 (haven't tried FSX
>>>> t) -btw, the video card is a 7900GTX.
>>>>
>>>> About 5 minutes after the system has been up & running, I get another
>>>> error, this time it says CNDNDlg ( I think that 6th character is a 'I")
>>>> stopped working and was closed. I do not see anything that closed
>>>> right off hand and the machine seems to run normally
>>>> I goggled it and it found nothing. Also nothing in the MS knowledge
>>>> base, (at least I couldn't find anything)
>>>>
>>>> The only other additions were Snappy Fax and FS2004. Snappy Fax is
>>>> working and FS2004 isn't loaded, or at least I am not running it.
>>>>
>>>> Any ideas?
>>>>
>>>> Thanks
>>>>
>>>> --
>>>> ..Chip..
>>>> For better or worse, we're
>>>> running Windows Vista
>>>>
>>>>
>>>>
>>>
>>
>