sss
"Tech_vs_Life" <limited@newsgroups.nospam> wrote in message
news:45A7EAEC-103C-42AF-B0F0-14E03088D25F@microsoft.com...
>I have a local network adapter, and whenever I check the property sheet for
>its ipv4 settings, it is always blank for the user-defined ip and subnet
>mask, even after adding them in. (that is, after adding them in and going
>back to check, the settings are blank). (Default gateway is fine).
>
> When I run ipconfig, it shows two ip addresses for the adapter (x.x.x.124
> and x.x.x.129).
>
> Any suggestions? I've tried resetting the adapter, deleting the driver,
> and a few other things, to no avail. is there a utility that can be
> downloaded that can diagnose this? Or a registry setting to delete?
>
> Thanks.